Here they are. Been a little bit of work but printing the hubs now. I’m thinking about messing around with the design so it can use some M3 nuts since 3d printed threads arnt the best
-
Welcome to RCTalk! 🚀
Join the #1 RC community where hobbyists connect, share, and get expert advice on RC cars, trucks, boats, drones, and more!
- ✓ Friendly & passionate RC enthusiasts
- ✓ RC tips & troubleshooting
- ✓ Buy, sell & trade RC gear
- ✓ Share builds & upgrades
Some 1.9 Crawler Rims I Made
- Thread starter Addict Rc
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
links, including eBay, Amazon, and others.
Doom!
Team Dust Devil
Community Leader
Lifetime Supporter!
Supporter
Excellence Award
Hospitality Award
Build Thread Contributor
RC Showcase: 6
- Messages
- 18,112
- Reaction score
- 43,524
- Points
- 2,690
- Location
- Central California
- RC Driving Style
- Bashing
- Crawling
- Scale Builder
- Flying
Lookin' good! 
- Thread starter
- #3
Thanks!Lookin' good!
Tunedfrog
Kermit the frog is a sissy.
Supporter
Excellence Award
Hospitality Award
Military Veteran
Build Thread Contributor
RC Showcase: 10
- Messages
- 17,396
- Reaction score
- 37,863
- Points
- 1,875
- Location
- Idaho
- RC Driving Style
- Bashing
- Crawling
- Scale Builder
Looks great. I'm thinking you may lose some weight down below where it's needed. Not sure if they are lighter or not honestly.
- Thread starter
- #5
Yes. But I was talking it over with my buddy. It’s kinda an advantage though. Less weight on the axle shafts which will lessen the chances of damage
Tunedfrog
Kermit the frog is a sissy.
Supporter
Excellence Award
Hospitality Award
Military Veteran
Build Thread Contributor
RC Showcase: 10
- Messages
- 17,396
- Reaction score
- 37,863
- Points
- 1,875
- Location
- Idaho
- RC Driving Style
- Bashing
- Crawling
- Scale Builder
I get your theory and reasoning, but I've never damaged a axle shaft because of aluminum wheels.
I hope they work out for you bud.
I hope they work out for you bud.
- Messages
- 9,786
- Reaction score
- 5,669
- Points
- 2,315
- Location
- Great Smoky Mountains
- RC Driving Style
- Bashing
- Crawling
- Scale Builder
- Flying
WTH? I need a 3D printer. That's amazing.
Tunedfrog
Kermit the frog is a sissy.
Supporter
Excellence Award
Hospitality Award
Military Veteran
Build Thread Contributor
RC Showcase: 10
- Messages
- 17,396
- Reaction score
- 37,863
- Points
- 1,875
- Location
- Idaho
- RC Driving Style
- Bashing
- Crawling
- Scale Builder
I agree, they look great.
Similar threads
