hey guys! i have a slayer that i have been playing with. last time i ran it when i give it alot of throttle it would pull hard to the left. and the left rear inner drive shaft had twisted a pretty good bit. i had just installed a rear spool and changed the rear toe in. is the twisted drive shaft causeing it to pull to the left? thanks!
-
Welcome to RCTalk! 🚀
Join the #1 RC community where hobbyists connect, share, and get expert advice on RC cars, trucks, boats, drones, and more!
- ✓ Friendly & passionate RC enthusiasts
- ✓ RC tips & troubleshooting
- ✓ Buy, sell & trade RC gear
- ✓ Share builds & upgrades
slayer questions
- Thread starter slick
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
links, including eBay, Amazon, and others.
Check for a stripped wheel hex.
mtaylortank
Hardcore RCTalk User
you should always keap your driveshafts in good condition.. cause that could cause alot of wobble with your rig. If that isnt whats causing it to pull to the left it is probly causing something else you havent noticed yet...
Similar threads
