i took my servos off to clean them and water proof them, now how do i make sure that they are back on in the right place. i plugged the battery in and turned them on and found where they are center in a nutral position, then placed the so it was center and "ex. the gas is not on at all, and the brakes are not on" did i do this right?
-
Welcome to RCTalk! 🚀
Join the #1 RC community where hobbyists connect, share, and get expert advice on RC cars, trucks, boats, drones, and more!
- ✓ Friendly & passionate RC enthusiasts
- ✓ RC tips & troubleshooting
- ✓ Buy, sell & trade RC gear
- ✓ Share builds & upgrades
servo question
- Thread starter a dawg
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
links, including eBay, Amazon, and others.
I don't quite understand.
Are you saying that once you installed the servo that it doesn't move?
Are you saying that once you installed the servo that it doesn't move?
I think that's the correct way.
I've made the mistake of putting the servo horns on before turning on the receiver bats and xmitter...
It's best to turn the stuff on, then do what you did.
I've made the mistake of putting the servo horns on before turning on the receiver bats and xmitter...
It's best to turn the stuff on, then do what you did.