Savage clutch-flywheel set-up

[tidd1340]

About to put my XTM 24.7 in my Savage roller and I need to buy a flywheel and clutch..i was going to go with a 2 pin stock flywheel and a MIP clutch..any thoughts?

 

[olds97_lss]

I just went with a 3-shoe variety that SkyMaxx recommended.

I bought this stuff from tower: Flywheel Clutch Shoes Clutch Bell CB Bearings

I should have went with a smaller CB though. I think this one is putting a bit to much strain on my engine. Although, it was shifting into second way to early before the engine was even remotely rev'd up. I adjusted it last night, but haven't run it yet. But the clutch hooks up really well. No slipping.

 

[newnitrofan]

If you are running that much horsepower in a motor it would be recommended for you tou use a 3 shoe setup. Olds has recommended a good setup for you. You also might take a look at the mugen seiki setup think hobbieguyrc on ebay sells them for $25 or $26 dollars.

 

[Maskale]

3 shoe

 

[hb1111]

i just bought a nova 3 shoe aluminum set ebay 19.99 + shipping

 

[pissant]

def. go with the 3 shoe setup, thats what iam using and man is it insane with my picco .26

 

[tidd1340]

Sounds like the three shoe wins..thanks guys.