• Welcome to RCTalk! 🚀

    Join the #1 RC community where hobbyists connect, share, and get expert advice on RC cars, trucks, boats, drones, and more!

    • ✓ Friendly & passionate RC enthusiasts
    • ✓ RC tips & troubleshooting
    • ✓ Buy, sell & trade RC gear
    • ✓ Share builds & upgrades

Savage clutch-flywheel set-up

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
T

tidd1340

RCTalk Qualifier
Messages
166
Reaction score
0
Points
0
RC Driving Style
About to put my XTM 24.7 in my Savage roller and I need to buy a flywheel and clutch..i was going to go with a 2 pin stock flywheel and a MIP clutch..any thoughts?
 
I just went with a 3-shoe variety that SkyMaxx recommended.

I bought this stuff from tower: Flywheel Clutch Shoes Clutch Bell CB Bearings

I should have went with a smaller CB though. I think this one is putting a bit to much strain on my engine. Although, it was shifting into second way to early before the engine was even remotely rev'd up. I adjusted it last night, but haven't run it yet. But the clutch hooks up really well. No slipping.
 
If you are running that much horsepower in a motor it would be recommended for you tou use a 3 shoe setup. Olds has recommended a good setup for you. You also might take a look at the mugen seiki setup think hobbieguyrc on ebay sells them for $25 or $26 dollars.
 
def. go with the 3 shoe setup, thats what iam using and man is it insane with my picco .26
 

RC Builds

Back
Top