RS4 Evo 3+ Start Problem

[AstonM]

Hi all,

New to Nitro RC and have recently bought a RS4 EVO 3+.

Having much problem starting the engine using the pull starter which seem to work about once in 50+ pulls. I am hoping it is only because the engine is new and not broken in.

Has anyone the same experience with theirs and what they have done to improve the pull starter? Appreciate any advise.

 

[Karl M]

Its no the pull start, its the way it is tuned. Set your needles to factory settings, located in the manual. You will probably need to lean it a bit form there but keep it rich. Make sure your glow plug is good and glow starter is charged. It may help to pre-warm your engine with a hair dryer if it is really tight. Welcome to the site, this is a great place to learn.

 

[AstonM]

Thanks for the reply Karl, otherwise, this seems to be a pretty quiet forum.

Cheers again.