• Welcome to RCTalk! 🚀

    Join the #1 RC community where hobbyists connect, share, and get expert advice on RC cars, trucks, boats, drones, and more!

    • Friendly & passionate RC enthusiasts
    • RC tips & troubleshooting
    • Buy, sell & trade RC gear
    • Share builds & upgrades

Build Thread Rebuilding RS4 2 Today

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
Well...I started at 7 am and its 2:15, still at it. The only damn thing I'm missing is fuel line ;)
 
I need some my self, damn 3 hour round trip to the HS sux. I think I'm gonna order a couple of those 50ft rolls over at towerhobbies. Should last me a while.
 
Nice...i've got my rs4 2 sorta rebuilt. I've decided to pretty much replace all the major parts with aftermarket, so i'm stuck while I wait for funds. It will probably be several month before I get it rebuilt and ready to run since i'm gonna save for a rody c5 circuit.
 
joneser4u said:
I need some my self, damn 3 hour round trip to the HS sux. I think I'm gonna order a couple of those 50ft rolls over at towerhobbies. Should last me a while.

That SUX! My 45 min. each way is nothin now. I feel bad for you.
 
Lucky for me I found some fuel line in ths extra stuff that came with tne new Racer 2 I bought. If I only had the damn roto start shaft I'd try to crank this thing up.

Well this is practically a new car, so much was missing and the radio equipment was replaced. I just hope the engine is ok.
 
I would have started this thing last night but my glow plug ignitor was not charged up ;)
 
RCDad said:
I would have started this thing last night but my glow plug ignitor was not charged up ;)

This is one reason why I own four glow ignitors plus one that can be hooked up to a car battery
 
Back
Top