• Welcome to RCTalk! 🚀

    Join the #1 RC community where hobbyists connect, share, and get expert advice on RC cars, trucks, boats, drones, and more!

    • Friendly & passionate RC enthusiasts
    • RC tips & troubleshooting
    • Buy, sell & trade RC gear
    • Share builds & upgrades

RCTalk VRC Race Club (VRCT)

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
I will take a look when I get home this evening.
 
I don't have one with one wire, mine has the basic three wire plug like an esc would have.
 
Really? I have one with one wire and one with 3.
 
Mines the v3 I think.
 
I am pretty sure you are right since you got it just just before the season starts.

I am also sure that the adapter I have has 3 wires going into each plug. Not positive since it has been plugged into the receiver since I got it over 3 years ago.
 
Sure enough. Both plugs have 3 wires on mine.

Got a run in.

Track condition was a lot looser than in practice. I could not hug the turns like I was used to. AI were a HUGE problem. They were slower than me so I was constantly trying to pass which was tough. Twice during the race I came up on a wall of 5 AI's. Took 3 laps or so to get around them. I hate their blow and go pit stops. They should have to sit there for a bit before taking off. At one point I saw the yellow car enter the pit as I was coming up to the 180. In the time it took for me to get around the 180 and then get to the pit exit, he came out right next to me. That is BS.
 
I just ran a lap via keyboard incase I can't get my adapter to work before monday, atleast I'll get my points that way....
 
I just went to run again and luckily ran some warm-ups since my low voltage alarm went off while doing so. It will be an hour before it's charged so I probably won't give it another go tonight.
 
I just noticed my run was faster than Petes lol, maybe I'll stick to keyboards lol.
 
Put in another run.

Had it not been for a couple of bumps with the AI's I would have added a lap.
 
I just beat Petes last run by 3 seconds...Adapter or not, I'm in it till the end!!!! :hehe:
 
Is your adapter toast?
 
Yeah I can't get it to work. I tested my radio and it works fine so its gotta be the adapter. The computer recognizes it too but I have no controls when I calibrate.
 
Back
Top