rc18t trouble

[robmob]

Take a look at the step 10 pic on this link. http://www.rccaraction.com/articles/ht_avoid_mistake_3.asp

 

[grgbulldog]

so it just goes until the paper is between? it doesn't really say how close to put them

 

[RatzoRC]

It's pretty "self explanatory".
Cut a thin piece of paper, push the gears together with the paper between the gears, then tighten the motor or engine screws. The paper will set the mesh for you.

 

[grgbulldog]

ahhh ok

ill try it

 

[RatzoRC]

Good Luck.

 

[grgbulldog]

lol thank you I'm gonna need it

 

[FastEddy]

Hmm.. 1+1+1= 4 today

 

[godale03]

40 bucks isnt too bad, do you need a soldering iron to install new motors?

The mini max is a great mill!... and Yes you will need a soldering iron to install a new motor.

Tom

 

[joey]

the mini-max should already have the motor leads on it for the stock esc...

 

[MR4X4KING]

maybe this will help i just found it
http://cgi.ebay.com/ws/eBayISAPI.dl...MEWA:IT&viewitem=&item=170058942792&rd=1&rd=1

 

[grgbulldog]

something odd has happened with my 18t motor. the magnet inside...at least i think its a magnet...I'm dumb if the dont even have magnets...but thats what it looks like, has drifted over so i can see it throught botrh gaps in the shell of the motor

 

[grgbulldog]

anybody?

 

[FastEddy]

Maybe 1+1+1 does = 3

 

[grgbulldog]

i really dont get it

 

[FastEddy]

Buy A New Frigging Motor!!!

 

[Lessen]

yeah, just buy a new motor.. an Orion stocker is like $12

 

[grgbulldog]

one of the wheel nuts is badly stuck and is getting stripped from trying to take it off, what can i do?

 

[Bryson]

What? How tight did you put the wheel nut on there! It should just be a little more than finger tight with the wrench. If you can get it off just go buy a new one, simple. When you go get a new motor pick up some wheel nuts. I have the reedy and its a great motor. Its pre-wired, no sodering iron needed, just plug it in a go.

 

[grgbulldog]

i just ordered 70 bucks in parts but not a new motor lol, this ones fine for now, i just ordered the necesities, and i got new nuts, i got the old nut off with pliars

 

[hamz9561]

Drilling Holes

:goodpost:I did the same mod to my 18t a few weeks ago and have since had no problems doing any work on the suspension. I wish I could say that I was the first to think of it lol.:LoL: