Could having the gear mesh to tight cause my car not to idle? The bell spins freely with the engine off but when I start it, the wheels won't stop moving. I got the throttle trim down to the lowest point where the engine won't quit, I even have to open it up a little to fire it back up. This is a new engine so its running really rich and I don't want to start breaking it in until I can get it to idle. Or could this be the clutch shoes?
-
Welcome to RCTalk! 🚀
Join the #1 RC community where hobbyists connect, share, and get expert advice on RC cars, trucks, boats, drones, and more!
- ✓ Friendly & passionate RC enthusiasts
- ✓ RC tips & troubleshooting
- ✓ Buy, sell & trade RC gear
- ✓ Share builds & upgrades
Question about gear mesh
- Thread starter davidac49
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
links, including eBay, Amazon, and others.
Alexander_0_1
"Roads, where we're going we don't need roads"
Check your clutch shoes and springs they might be worn out
Classic sign of a broken or stretched clutch spring, pull the CB for a looksee.
