pull-start for new os .18tm engine???

[SkyAce2004]

i just got a new OS.18 engine for the revo. the EZ start bearing is seized onto the other motor and dont wanna bother with it. i got the engine specially fitten for the revo. is there gunna be a problem converting it to pullstart? the easy start is just a pain in the ass.

thanks!

someone with this engine in the revo, can you help me please? i got the engine mounted so i could re-adjust the throttle arm. well, i got it setup, but it wont go WOT. it will go as far as it can, then the arm just flexes to releive th estress....

help?

 

[rx7r695p]

Roto Start

Just slap the roto start in there... These one way bearings are going to seize from time to time but don't forget to preorder your revo starter box from RD Racing....

 

[basher]

I had the same problem with the throttle... try loosening the carb screw, apply WOT (the carb will rotate around), then while holding WOT tighten the carb screw. It took me a few tries but I finally got it. You might even want to try using a different hole on the servo horn. Hopefully i can go break my 18 TM in tomorrow.

 

[SkyAce2004]

i just fixed the problem. i got through 2 tanks of idling, andouter 2 of 1/4th throttle puttin around, 1 with 1/2th throttle

was gunna slowly make my way to WOT but it just wouldnt go, i looked and i just put the thing the push arm connects to on the other mount, about 3mm behind the other one. it works sweet now. i gotta finish breaking it in wednesday though.