problems again........help please...

[elmoredarren1]

ok this is what is going on. I ran my car and ran perfect cleaned it up and put it up. then go to race 2 weeks later and car started right up but will not move give it full throttle and doesn't move but if it does move just very slow....like not moving... need help of what you think it might be and maybe a site that shows this part and where it is on the car like a exploded view of what you think it might be....
thanks guys
darren

 

[olds97_lss]

What did you clean it with? If you rev it with the body off, do you see the spur spinning even though the truck doesn't move?

I got lube on my slipper by accident once... caused a similar situation. I was trying to lube the spur gear and got a little nuts.

 

[smokedsalmonkid]

could it be your slipper clutch is too loose?

my

 

[bustedgears]

It could also be the clutch slipping. Mine did that once.

 

[beason]

could be exesive use of after run oil soaked the clutch, or the slipper pad. could be rusted wheel bearings if you got it wet at all.

is it reving hi and barley moving or bogging and barley moving?