roundrocknitro
RCTalk Rookie
- Messages
- 23
- Reaction score
- 0
- Points
- 0
- RC Driving Style
just got a RS4 EVO today but the enegine wont rotate past tdc w/ glow plug in what gives?
-
Welcome to RCTalk! 🚀
Join the #1 RC community where hobbyists connect, share, and get expert advice on RC cars, trucks, boats, drones, and more!
- ✓ Friendly & passionate RC enthusiasts
- ✓ RC tips & troubleshooting
- ✓ Buy, sell & trade RC gear
- ✓ Share builds & upgrades
problem w/ brand new T-15
- Thread starter roundrocknitro
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
links, including eBay, Amazon, and others.
militarymaxx
RCTalk Addict
This is common in new engines. The tolerances between the piston and the sleeve make for a very tight fit. The engine might also be a little dry on the inside. Remove the glow plug, drop in a few drops of ARO and move the piston through its' cycle a few times. Once you've cycled things a bit, re-install the glow plug and follow the break-in procedure.
roundrocknitro
RCTalk Rookie
- Messages
- 23
- Reaction score
- 0
- Points
- 0
- RC Driving Style
- Thread starter
- #3
ok i got it working. i think there may have been a little extra aro in it. i spit it out and seems to run fine now. Thx.
roundrocknitro
RCTalk Rookie
- Messages
- 23
- Reaction score
- 0
- Points
- 0
- RC Driving Style
- Thread starter
- #4
ok i got it working. i think there may have been a little extra aro in it. i spit it out and seems to run fine now. Thx.
