Over tightened high speed

[josphisyeet]

I tightened my high speed to much will that have damaged the needle? I have a hobao hyper 7 .21

 

[tudordewolf]

I tightened my high speed to much will that have damaged the needle? I have a hobao hyper 7 .21

It's possible - what's most likely to happen is the o-ring gets damaged and doesn't seal right anymore; replacing that would fix the problem.

 

[Bogda89]

I tightened my high speed to much will that have damaged the needle? I have a hobao hyper 7 .21

Well, it's tough to say. Is it a metal or plastic carb. The best way to know for sure is to run the engine. If it still run properly than not

 

[Monkey Wrench]

Well, I'd reset the needles to factory, see how it runs then go from there. As was mentioned, may be a torn o-ring.

 

[josphisyeet]

Well, it's tough to say. Is it a metal or plastic carb. The best way to know for sure is to run the engine. If it still run properly than not

I’m not sure its brand new. I heard that sometimes the carb settings are off so i reset them and tightened it till i would go any further in
Hasnt been run yet
The needle bit looks the same as ones for sale
Is it worth keeping the .21 its the 3 port one