Ntc3 Steering Problem

[jon2]

Ok I just got a brand new Nitro TC3 and I am so excited!! but I noticed that the steering set up doesn't allow me to adjust my steering trim much! How do set up my servo so I have equal amounts of adjusting my steering ?I have a futaba FT2PH and the knobs do not give me an indication on where center is? I will post my pics as soon as I am finished with my paint job...I am doing it myself.Did I say this is my first time painting one by airbrush?:devious:

 

[Nitroaddict]

to set the steering up straight - do this. remove the steering servo control horn. turn the radio on, and set the steering trim to zero. install the servo control horn back on the servo, with the horn 1 click to the right of top dead center. this is how the instructions indicate for you to do it.

 

[jon2]

I probably missed that part so I will do that again.THanks NitroAddict

 

[Nitroaddict]

no prob man - I've had my NTC3 for a while now - so lemmi know if u have any more questions.

 

[jon2]

Please check out my other post "12 RSS into a NTC3"