nitro pull start one way bearing

[ibiza_95]

hi, i have an NTC3 with pullstart and the one way has gone pretty crap now. found one on ebay for a kyosho? any chance if anyone knows if itll fit mine? i presume there will be a few similar one way bearings for pull starts so thought id ask.
cheers:buggy1:

link:
http://cgi.ebay.co.uk/KYOSHO-NITRO-...ryZ34063QQssPageNameZWDVWQQrdZ1QQcmdZViewItem

 

[Monkey Wrench]

It really depends on the engine, not the actual model. If you can share what engine you have, it'll help.

 

[ibiza_95]

its a standard NTC3 team associated .12 engine
Thanks

 

[Monkey Wrench]

Best bet is to go with a OWB manufactured specifically for that engine. While you may be able to find a OWB that fits on the shaft, it may not fit in the recoil housing then you're stuck with a OWB bearing you cannot use.

You may be able to salvage the one you have for at least a little longer. Soak it in some DA to get it good and clean then apply a very light coating of WD-40. May add some time to the OWB.

 

[ibiza_95]

cheers... i suppose i should just buy a new one way specific for the engine really. its 20pounds here! thats about $35!!!!!!!!!!!