I took wheels off to clean them and when put back on when the car accelarates the front wheels have a problem. the only way i can explain it is if you have a football with an egg in it and you spin it in the air it does not quite go round in a perfect circle, well that is what the front wheels are doing. can anybody help
-
Welcome to RCTalk! 🚀
Join the #1 RC community where hobbyists connect, share, and get expert advice on RC cars, trucks, boats, drones, and more!
- ✓ Friendly & passionate RC enthusiasts
- ✓ RC tips & troubleshooting
- ✓ Buy, sell & trade RC gear
- ✓ Share builds & upgrades
new guy with problem with hsp nitro truggy
- Thread starter nat
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
links, including eBay, Amazon, and others.
Thread moved to appropriate forum.
How did you clean them?
If you used water, you most likely soaked the foams inside.
If this is the case, you can poke some holes on the outside of the tires and spin the water out by blipping the throttle with the rig off the ground.
How did you clean them?
If you used water, you most likely soaked the foams inside.
If this is the case, you can poke some holes on the outside of the tires and spin the water out by blipping the throttle with the rig off the ground.
Poke 2 holes in the center of the tire tread area 180 degrees from each other.
Best way is to use a body reamer. Don't go in any further than to make a hole that is the same size as the ones on the rims which should be roughly 1/16" diameter.
The rubber will make it look like there is no hole. If you squeeze the tire and feel air come out of the puncture you made, it will work.
Best way is to use a body reamer. Don't go in any further than to make a hole that is the same size as the ones on the rims which should be roughly 1/16" diameter.
The rubber will make it look like there is no hole. If you squeeze the tire and feel air come out of the puncture you made, it will work.
