need 2 kno if a losi bell gear will fit on a xtm .18

[RC4LYFE]

hey
ok see cuz i usualy have a 47 tooth spur gear, but i striped it and i used a losi 57 tooth as a replacement but its badly meshed and striping slowly, which is wierd, not getting melted like you can see the losi gear's teeth getting smaller and i actualy brooke 4 off 2day, so i need a losi bell gear so i can have a 57 toothe spur cuz IT GOES FAST!!!! if you can tell me if this would work, or if i caoul use somthing to make the losi spur work thank you so much!!!

my x-c was on the edge of poping wheelies!, NO LIE and it was spining out sometimes it had so much power,

thanks.

 

[lykan]

Maybe your X-C is not tunned so good? My X-C with the .18 and stock gearing wheeelies all over. It's hard to control. IT's also hard to keeep the front on the ground. I have no troubled doing donuts on any terrain (except deep grass).

Have you changed the tires to bigger ones?

 

[RC4LYFE]

no man everything is stock.
whats all your needlie settings at?, do you have to tighten your spur gear nut or somthing??

thanks-

 

[lykan]

I set the neeedles to stock everytime I go out, then I lean as neeeded for conditions. My slipper is tight enought to spin, and hweelie, but not tight enough to strip gears and break transmission parts.

I found tuning it from factory everytime out makes it a lot easier to handle/tune. I get a lot more power that way.

 

[RC4LYFE]

yea i just got the 46 tooth today and out of no were! bam wheelie like totaly vertical i gess i meshed it and tightend every thing good, what luck, but my enegine needs some tuning, it stalls often, but yea, wheeling is crazy so diffrent than what i thought it was going to be like, its kinnda scarry
thanks for the info and help lykan


:music: