• Welcome to RCTalk! 🚀

    Join the #1 RC community where hobbyists connect, share, and get expert advice on RC cars, trucks, boats, drones, and more!

    • Friendly & passionate RC enthusiasts
    • RC tips & troubleshooting
    • Buy, sell & trade RC gear
    • Share builds & upgrades

Should I run my slash on an infinite electricity loop run by 2 brushed motors and a chain?

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
That's not just a guess, it's for sure!!!
Mike, that sounds like it would make a good closing act at 2 am. Get everyone to leave the building.
I used to go on stage early. Everyone would throw their change at me. 🤷‍♀️🤣
 
My guess is the amount of energy it will take to power the primary motor to both push the truck around, and spin the dynamo to recharge the battery will be far more than what little you can generate with a dynamo that size. If it were that simple, then every electric car on the planet would be setup that way.
I might need to get someone to build a circuit board for splitting the electricity into 2 equivalent power sources; one for the other motor, and one for the esc power
 
I might need to get someone to build a circuit board for splitting the electricity into 2 equivalent power sources; one for the other motor, and one for the esc power
Yeah, that's still not gonna solve your problem.
 
Like all vehicle efficiency projects that defy physics big oil is probably going to shut this down before his project is complete.
The only thing in this version of the multiverse that has been proven to break any law of physics is sperm...really...it's worth a Google.

Until someone engineers a motor that runs on man mayo, we're still bound by the laws of science.
 
Back
Top