I got this when the rollers were on sale in November 2021 and intended on building it up over the winter for next season. I got most of the stuff for it before it got too cold to run it, so I was able to get a couple bash sessions on it anyway.
Kraton 6S EXB Roller
Max6 with Surpass 35mm alloy framed fan
Rocket 4092 1650kv - 19T pinion and TRB hybrid ceramic bearings
NHX dual 30mm fan motor cooler with alloy framed fans and generic fan guards
M2C rear tower brace
3D RC wing mount - red
3D RC front bumper spring - black, then later got the red one when it was in stock
Backflip MT's wrapped
ProbodyRC Body
hobbystar hcs-4521 servo
v2 outcast servo saver (with red loctite)
Lunsford tie rods - broke a stock one 35 seconds into the first run, my fault for overstacking the stock servo saver spring
PPS motor mount/cover/front center diff support - moved the old mount to my outcast
Changed all diffs to open diffs and running 100k/500k/100k oil.
T-Bone rear skid/wheelie bar
Bearings for steering posts
When I got it, 11/15/2021:
Couple weeks later when some of the stuff showed up, 12/01/2021:
Started working on it, 12/07/2021:
Got a HR clone center diff cover, thought it was an actual HR one, 12/20/2021:
Lunsford tie rods, 12/21/2021:
My wife got me the PPS motor mount system for Christmas, 12/25/2021:
ProbodyRC body finally showed up, ordered it shortly after getting the truck, 12/28/2021
Got the body cut, stickered and installed, also got the red 3DRC front bumper spring and some roof skids off ebay, 01/09/2022:
How it is now, changed the pinion to a 20T, not sure if that will be too high and cause the motor to run hot. 01/09/2022:
Kraton 6S EXB Roller
Max6 with Surpass 35mm alloy framed fan
Rocket 4092 1650kv - 19T pinion and TRB hybrid ceramic bearings
NHX dual 30mm fan motor cooler with alloy framed fans and generic fan guards
M2C rear tower brace
3D RC wing mount - red
3D RC front bumper spring - black, then later got the red one when it was in stock
Backflip MT's wrapped
ProbodyRC Body
hobbystar hcs-4521 servo
v2 outcast servo saver (with red loctite)
Lunsford tie rods - broke a stock one 35 seconds into the first run, my fault for overstacking the stock servo saver spring
PPS motor mount/cover/front center diff support - moved the old mount to my outcast
Changed all diffs to open diffs and running 100k/500k/100k oil.
T-Bone rear skid/wheelie bar
Bearings for steering posts
When I got it, 11/15/2021:
Couple weeks later when some of the stuff showed up, 12/01/2021:
Started working on it, 12/07/2021:
Got a HR clone center diff cover, thought it was an actual HR one, 12/20/2021:
Lunsford tie rods, 12/21/2021:
My wife got me the PPS motor mount system for Christmas, 12/25/2021:
ProbodyRC body finally showed up, ordered it shortly after getting the truck, 12/28/2021
Got the body cut, stickered and installed, also got the red 3DRC front bumper spring and some roof skids off ebay, 01/09/2022:
How it is now, changed the pinion to a 20T, not sure if that will be too high and cause the motor to run hot. 01/09/2022: