Make an RWD 1/24 drifter for just 80$

[Antlers]

I have always thought the cost of entry to rwd drifting was way too high, and the only cheap options were an LDRC or my D12 drift conversion (I'll make a thread if y'all wanna learn about that). But nothing was in 1/24 scale for a way to test the waters without going all in on a $300+ build so I made a way! Start with a K989/K969 and the gyro in the links below. watch this video to wire the gyro properly:

. After setting up the gyro, remove the driveshaft and use my conversion kit to achieve a high steering angle with minimal hassle. Next print a set of drift tires and let it slide!

Links:
K989: https://www.amazon.com/GoolRC-WLtoy...89&qid=1777044547&sprefix=k989,aps,231&sr=8-7

Gyro: https://www.amazon.com/Stabilizer-4...id=1777044800&sprefix=rc+gyro,aps,130&sr=8-37

My kit: https://www.thingiverse.com/thing:7340879

Recommended tires: https://www.thingiverse.com/thing:4880081

 

[Ramp addict]

I don't normally think of small trucks as being super controllable. That video was pretty good.

 

[Antlers]

I don't normally think of small trucks as being super controllable. That video was pretty good.

the video is not mine, it is from a channel called "kuikmix"