m26ss engine

[black&mild]

i have a aftershock with a m26ss seem to have some problems keeping it tune revs really high when it what owb bad is this worth fixing or should i buy a new motor would appreciate any info its been giving me trouble since i got it

 

[olds97_lss]

That hurt my head...

It rev's really high when what?

Have you cleaned the OWB?

Mine was leaking everywhere and ran like junk until I tore it apart and cleaned/sealed it. The carb neck, back plate and LSN leaked. I sealed the carb neck and backplate with RTV and I used associated green slime on the LSN. That helped immensely.

If cleaning the OWB with DA and re-oiling it doesn't make it start grabbing again, the I don't think I'd spend the money to fix it. Unless you can get a new starter shaft and OWB cheaply on ebay. IMO, it's a throw away engine. Good to get you going, but not really worth fixing when it starts to fail.

 

[black&mild]

m26ss

revs high at ramdom it runs great for awhile then start to rev hard to break in in i have may ten tank threw it

i did clean the owb started it work the next day it didnt

 

[SMaxxin]

It sounds like you have an air leak.

 

[olds97_lss]

Oh. If your doing break in, it's probably just rich and fouling up your OWB.

Check your fuel filter. Mine leaked like a sieve out of the box. The o-ring between the two halves was damaged. Made my first 4 tanks a total drag... I noticed it when I gave up and went home.

 

[black&mild]

m26ss

i plugged all the holes and blew air in it and your right air coming from my head button shaving all around my glow plug

 

[v12revo]

Your gonna need a new button head ($10)