Losi SCT-E problem

[WazabiQc]

Hey ! i just got a Losi sct-e about a month ago, setup is sr301 Receiver, Fuze 540 motor with Fuze waterproof 130A ESC, and i run a lipo 5700 mAh, 2S 35C Battery. at first i was running a 2055 Traxxas servo, which wasn't powerful enough, so i switched to a Spektrum S6030, but since i changer servo , when i'm running the motor suddenly stops and wheels line up straight, as if the receiver would go into Failsafe mode, then it returns to normal after 1-2 seconds. What could cause this ? is it possible that my servo is draining too much power and the whole system jams ?

 

[tmaxxfreek]

buy you a glitch buster and install it, that should fix your problem.

 

[WazabiQc]

any more info about glitch buster ? don't even know what it is !

 

[Sixtysixdeuce]

any more info about glitch buster ? don't even know what it is !

A capacitor that stabilizes receiver output. Plugs into ch3 or VCC port.

However, I'm not sure that's your issue. Glitchbusters help with a twitchy servo, but your situation sounds more like a momentary loss of tx/rx comm; does throttle/brake function remain normal?

 

[WazabiQc]

no they don't ! it like i would swith the receiver off !