k2 linkage ,T/B

[dmckie]

I got a used kyosho k2 roller,I have been getting it ready to run ,and put in my airtronics servo for the t/b .I notice that the lower slider for the front brake linkage , rubs the top of the servo.the thumb adjuster that is on the linkage also prevents the horn from going full brake, because it hits the side of the servo. I have tryed different horns and still can't get the linkage to clear the servo does anyone have any pic's of there T/B setup they can show me ?has anyone run in to that problem and what did you do? Is there a servo horn out there that sits up higher from the top of the servo.



This is what I thought of doing ,But then the angle of the linkage would be way out..any Ideas
http://www.msnusers.com/peodnkl7cdjqsgg94s9njh7fr6/Documents/Pictures/untitled.jpg

 

[madnking]

Dynamite makes a throttle/brake linkage already put together ready to install and tune. Makes it eazy, your linkage rods might be too short if they are hitting the servo try longer rods with fuel tubing to take up the gap.

 

[dmckie]

Ok I'll give that a try ,thanks.

 

[NITRO 21]

Madnking do you have a link to the Dynamite throttle/brake linkage set are does anyone no where I can get just the linkage rods without the horn because I could use a few and can not seem to find just the rods.