Bcfab
RC Newbie
New to nitro.. I think I got the high speed, runs good but when you bring it the truck pushes forward. Idle screw does not bring idle down.. Suggestions
Mike
Mike
-
Welcome to RCTalk! 🚀
Join the #1 RC community where hobbyists connect, share, and get expert advice on RC cars, trucks, boats, drones, and more!
- ✓ Friendly & passionate RC enthusiasts
- ✓ RC tips & troubleshooting
- ✓ Buy, sell & trade RC gear
- ✓ Share builds & upgrades
Idle problems
- Thread starter Bcfab
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
links, including eBay, Amazon, and others.
Childresshunt
RCTalk Addict
As long as you feel your hsn is tuned well and you have your idle gap set to 1mm about at big as the end of a paper clip to fit in it then you prob need to richen your lsn some
