Hyper 8 port

[4u2nv]

I was wondering if anyone knew of a site or had any info on factiry settings on a Hyper 8 port .21 engine. Also a what screw does what guide (Sounds kinda dumb but I'm mixed up between 2 of them)(I'm trying to adjust my idle) Thanks again!! (what would I do without this site???)

 

[SkyMaxx]

This link should get you started: CLICK HERE

Note, it is a download for the PDF version of the Hyper .21 user manual.

It has the needle settings and pictures to explain which needle is which. If it does not answer your questions, let me know.

 

[ZANDOR]

sorry andy i forgot to send you the book..my bad.
ok here is a run down the hsn is the tall brass one factory setting is 4.5 to 5 turns out..
mid speed needle is the brass one on the side of the carb. keep that one flush with carb body.and forget about it..

the lsn is on the carb slide factory setting is 3.5 turns out from flush of the end of the slide..

idel is located right under the hsn needle its just a little screw..

if you have any questions pm me and all call you...zandor

 

[SkyMaxx]

Ummm...Zandor, the link I provided him is the book you forgot to send him.

 

[ZANDOR]

i forgot to add that he is on a dial up (slow) and probley whould take him all nite to down load....lol

 

[SkyMaxx]

At 96kb file size, I think he is golden...but you can explain all you desire.

Next time, send him the f'ing manual =devil