hub question

[syphon68]

I bought the Integy steering bells and carriers, but I can't figure out how to remove the hubs from the stock bells, any ideas? The pins in the hub won't budge even with a hammer and punch....


Thanks

 

[olds97_lss]

LST2 I'm guessing? If so, there are set screws in the ends of the axle holding the pin in place. The axle is hollow and threaded on the inside. Found that out with my first buggy... their the same way.

LST2 axle photo:

That set screw goes into the end of the axle to hold the pin.

If it's an LST1... I have no idea other than a pin that's rusted in.

This is an LST1/AS/Baja/Raminator axle, the pin just sits in the hole:

 

[syphon68]

Thanks for the help, yes LST2 and the secret was to get a bigger Hammerto get the pins outa the hubs:->