HR Gear case for 2WD Stampede

Welcome to RCTalk

Come join other RC enthusiasts! You'll be able to discuss, share and private message with other members of our community.

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.

Fboylstein

RCTalk Basher
Messages
52
Reaction score
33
Installed HR Gear/transmission case on brushed 2wd stampede. Ran it a couple times, not that hard and noticed back end was drooping. Gear case broke at both holes where body post mount go into. Any one ever heard of this issue before?? I just ordered a RPM gear case to try out. (See pic).
19B0C39A-3EB2-427D-AAF7-2932F1D701E2.jpeg
 
I've been running a rpm in 5 of my traxxas rigs. 2 r setup for Drag racing with 9000kv on 2 cell and those get beat on..
 
Thanks!! I heard good reviews on them. Hard to believe the HR case broke so easy. I know I installed it correctly.

Question? Did you have to shim yours?
Thanks again.
 
No shims but I did change all the bearing to a better grade when I assembled it.. along with idler gear..
 
Plastic case. Nuff said
 

Attachments

  • 36C2279A-84AB-49A1-BFF5-7461FD2DAEBC.jpeg
    36C2279A-84AB-49A1-BFF5-7461FD2DAEBC.jpeg
    159.2 KB · Views: 50
  • 257F5A7F-EA3C-44BE-AFFB-FEEB02373A69.jpeg
    257F5A7F-EA3C-44BE-AFFB-FEEB02373A69.jpeg
    193.9 KB · Views: 44
  • CA4D3BCD-A978-4159-ABCF-EA4DA5207F71.jpeg
    CA4D3BCD-A978-4159-ABCF-EA4DA5207F71.jpeg
    153.6 KB · Views: 49
Back
Top