-
Welcome to RCTalk! 🚀
Join the #1 RC community where hobbyists connect, share, and get expert advice on RC cars, trucks, boats, drones, and more!
- ✓ Friendly & passionate RC enthusiasts
- ✓ RC tips & troubleshooting
- ✓ Buy, sell & trade RC gear
- ✓ Share builds & upgrades
hpi conversion mt2??
- Thread starter rckid91
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
links, including eBay, Amazon, and others.
I think you just need the slipper assembly and center drive cups.
Slipper: http://www3.towerhobbies.com/cgi-bin/wti0001p?&I=LXFYP4&P=Z
Cups:
http://www3.towerhobbies.com/cgi-bin/wti0095p?FVSEARCH=86225&sourceid=mozilla-search
http://www3.towerhobbies.com/cgi-bin/wti0095p?FVSEARCH=86234&sourceid=mozilla-search
And these for the cups:
http://www3.towerhobbies.com/cgi-bin/wti0001p?&I=LXDLG8&P=ML
The NMT just used grub screws and had a flat spot on the shaft for it to tighten against. The MT2 runs a screw shaft through the center shaft.
Slipper: http://www3.towerhobbies.com/cgi-bin/wti0001p?&I=LXFYP4&P=Z
Cups:
http://www3.towerhobbies.com/cgi-bin/wti0095p?FVSEARCH=86225&sourceid=mozilla-search
http://www3.towerhobbies.com/cgi-bin/wti0095p?FVSEARCH=86234&sourceid=mozilla-search
And these for the cups:
http://www3.towerhobbies.com/cgi-bin/wti0001p?&I=LXDLG8&P=ML
The NMT just used grub screws and had a flat spot on the shaft for it to tighten against. The MT2 runs a screw shaft through the center shaft.
david41990
RCTalk Racer
I believe you indeed just need the slipper assembly and center drive cups there could be something else but I am pretty sure thats it ask your local lhs
