Hpi Blitz questions.

[HunterRc]

Hello I have a Hpi Blitz

HPI Blitz 1/10 Scale RTR Electric 2WD Short-Course Truck w/2.4GHz w/Waterproof Electronics this model ...i have swapped a 3800kv Caste 1410 Sct combo in and on 2s its a great truck perfect. But when I run it on 3s at about 40 ish Mph it will flip right over onto its roof and slide 50ft lol. any ideas too keep the front down? they do not make a wheelie bar for this truck.​

 

[DavidB1126]

More weight on the front
Cut holes in the body for vents to let air through

I did the same with my slash

 

[bill_delong]

Buy some 1/8" Kydex off Amazon and make your own custom wheelie bar, use a heat gun to shape it as necessary, then install wheels from an RC Plane on the rear of bar.... done

 

[biggman100]

Hello I have a Hpi Blitz

HPI Blitz 1/10 Scale RTR Electric 2WD Short-Course Truck w/2.4GHz w/Waterproof Electronics this model ...i have swapped a 3800kv Caste 1410 Sct combo in and on 2s its a great truck perfect. But when I run it on 3s at about 40 ish Mph it will flip right over onto its roof and slide 50ft lol. any ideas too keep the front down? they do not make a wheelie bar for this truck.​

As they said, you can either cut holes in the body so it doesn't parachute, make your own wheelie bar (personally, I don't like the look of wheelie bars, except on drag cars), or, what I do is a combination, by venting the body, and adding sticky weights to the front of the chassis. The weights are basically add until you find what works, but try not to do too many. This post will show how I vented my old Arrma Fury, https://www.arrmaforum.com/threads/lift-off.9993/#post-108105