El Pirata
RCTalk VIP
I wonder how hard it would be to add a bar that ran from the front shock tower to the rear shock tower to give added support between the two on an Inferno. Any suggestions?
-
Welcome to RCTalk! 🚀
Join the #1 RC community where hobbyists connect, share, and get expert advice on RC cars, trucks, boats, drones, and more!
- ✓ Friendly & passionate RC enthusiasts
- ✓ RC tips & troubleshooting
- ✓ Buy, sell & trade RC gear
- ✓ Share builds & upgrades
How hard???
- Thread starter El Pirata
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
links, including eBay, Amazon, and others.
uDi_MP7.5
RCTalk Talkaholic
Lookin good Nightmare, and I like your new tyres too. I see that you have snapped up some of the new 'pre-worn' tyres, similar to 'preglued' tyres, except they are 'worn' instead of 'glued'. :LoL:
The stock ones wear out eventually (plastic ballends), and aftermarket CNC ones are the same thing minus the wear, plus good looks. The way I see it, tower to tower offers more stiffening than bulkheads-to-chassis, but best of all run both.
EP - not 100% sure, but I was thinking a thick aluminium/steel/titanium rod with threaded ends, that thread into metal ends, that are attached to the front/rear bulkheads/shocktowers. That way, you can adjust (lengthen) to really tighten up the car... or loosen (shorten) it up if you find it leading to other parts breaking. Win-Win situation :yes:
The stock ones wear out eventually (plastic ballends), and aftermarket CNC ones are the same thing minus the wear, plus good looks. The way I see it, tower to tower offers more stiffening than bulkheads-to-chassis, but best of all run both.
EP - not 100% sure, but I was thinking a thick aluminium/steel/titanium rod with threaded ends, that thread into metal ends, that are attached to the front/rear bulkheads/shocktowers. That way, you can adjust (lengthen) to really tighten up the car... or loosen (shorten) it up if you find it leading to other parts breaking. Win-Win situation :yes:
Last edited:
