- Messages
- 1,492
- Reaction score
- 2,646
- Location
- Iowa
- RC Driving Style
- Racing
- Crawling
- Scale Builder
- Flying
Quick Sunday morning project. I have two crawlers to make links for. And I decided to remember to make a tool that drives the link onto the rod.
I used a 5/16 driver. It had a magnet unit but it was quickly removed when I cut the slot .
You want to pick two of the six points at 6 and 12. Mark make them on the outside and use a Dremel tool to cut the slot. For the link and hold the ball between two flat sides.
Quick clean up and polish then a coat of gun blue to finish it up.
I used a 5/16 driver. It had a magnet unit but it was quickly removed when I cut the slot .
You want to pick two of the six points at 6 and 12. Mark make them on the outside and use a Dremel tool to cut the slot. For the link and hold the ball between two flat sides.
Quick clean up and polish then a coat of gun blue to finish it up.