Anyone know where to get parts for these? I can't find anything for them, i really only need a pull start, i would think others would fit, but I'm not sure which others, i have read that these were pretty good engines,Can anyone help me out?
-
Welcome to RCTalk! 🚀
Join the #1 RC community where hobbyists connect, share, and get expert advice on RC cars, trucks, boats, drones, and more!
- ✓ Friendly & passionate RC enthusiasts
- ✓ RC tips & troubleshooting
- ✓ Buy, sell & trade RC gear
- ✓ Share builds & upgrades
Go B21 Engine.
- Thread starter tmaxxfreek
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
links, including eBay, Amazon, and others.
- Thread starter
- #2
I guess everyone had the same luck i did, i can't find anything.
Macguyver
Hardcore RCTalk User
- Messages
- 1,566
- Reaction score
- 3
- Points
- 678
- Location
- in the woods .Quebec Canada
- RC Driving Style
- Bashing
whats broken on your pullstart ? maybe its an easy fix
- Thread starter
- #4
its gone, no pull start at all, when i got it back he had taken it off and lost it
Macguyver
Hardcore RCTalk User
- Messages
- 1,566
- Reaction score
- 3
- Points
- 678
- Location
- in the woods .Quebec Canada
- RC Driving Style
- Bashing
measure the screw holes center to center ....i have a picco .26 , wasp .26 , wasp .28 and traxxas 3.3 ..they all have around 27.5mm ...I'm pretty sure you could use any pull start from a .26 or .28 engine that has the same screw holes 
- Thread starter
- #6
I dont have anything that measures in mm but it measures close to 1 1/16 inch which converts close to 27.5
Macguyver
Hardcore RCTalk User
- Messages
- 1,566
- Reaction score
- 3
- Points
- 678
- Location
- in the woods .Quebec Canada
- RC Driving Style
- Bashing
i would get one for a picco .26 ...it should fit .....if not , you can always sell it to me ..lol...mine is starting to give me problems
- Thread starter
- #8
ill see if i can find one that works, thanks Mac
