ok so i got my merv on Sunday for my b day. i ran it 3 times for about 15 min each time on flat concrete (plus a few flips). i broke it out again today to do a little bashin, through 14.4 on it and thrashed it for about 25 minutes and CLICK CLICK CLICK.. yep my rear dif is gone!!! so i opted to buy a new rear diff and pinion, along with some aluminum turnbuckles, and aluminium tie rods, oh and not to mention new steel center and individual driveshafts all around. not even a week old and she is getting some major hop ups. ill post some pics up as soon as i install them all.
-
Welcome to RCTalk! 🚀
Join the #1 RC community where hobbyists connect, share, and get expert advice on RC cars, trucks, boats, drones, and more!
- ✓ Friendly & passionate RC enthusiasts
- ✓ RC tips & troubleshooting
- ✓ Buy, sell & trade RC gear
- ✓ Share builds & upgrades
FML Revo VXL-0 to much Torque-1
- Thread starter Ajax_6154
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
links, including eBay, Amazon, and others.
adeezy9183
RCTalk Talkaholic
- Messages
- 287
- Reaction score
- 1
- Points
- 0
- RC Driving Style
- Bashing
i'm already putting in my 3rd ring and pinion. (diff gears) it's not too bad of a job. just make sure everything is clean. the standing backflips are a blast but your drivetrain will pay the toll of doing them. also it helps to NOT be on the throttle during landings. and I haven't even had a 3 cell lipo in mine yet...
adeezy9183
RCTalk Talkaholic
- Messages
- 287
- Reaction score
- 1
- Points
- 0
- RC Driving Style
- Bashing
Good luck!!!
