Flywheel replace or resurface?

[largaines]

had a bad bearing in the clutch bell and it scared up the flywheel pretty good. Is this going to cause any issues? Can only find a couple used on flea bay and they look worse. Should I pull the pins and sand the grooves out or run it?

 

[fstnd]

The flywheel looks perfectly fine. It doesn't matter wether the tops of the clutch holding pins are slightly damaged, they don't touch anything
If you do notice significantly more vibration when running the engine, I'd replace it though.

 

[largaines]

Thanks, I found a new old stock but apparently it’s made out of solid gold and has sentimental value. I’m trying not to spend more than the new gt10 will cost lol

 

[CertifiedMike]

Wobble would be my only concern I think.

Vintage gear is stupid money sometimes.

 

[monte7074]

had a bad bearing in the clutch bell and it scared up the flywheel pretty good. Is this going to cause any issues? Can only find a couple used on flea bay and they look worse. Should I pull the pins and sand the grooves out or run it?

View attachment 219385

Flywheel looks fine. I got worse looking on some of my cars