flysky gt2 help

[sata1991]

ok bought it from china first mistake twenty days later it comes i bind them and my Chanel one dose not work when i plug my steering in you can hear it twitch like power went to it but wont steer now my number 2 Chanel works great throttle works great is in a bad controler if i swap the servo cords the steering works by moveing the trigger god i am so mad

 

[slowngreen]

Could just be a bad reciever. Dont be mad since its such a cheap setup. You can replace the rx for cheap and hopefully that does it.

Does your rx look just like this one? This is in the US too by the way.

http://www.hobbypartz.com/fs-gtr3c-receiver.html

I've had one new rx from flysky be exactly like what you described.

 

[sata1991]

ok thanks but would i still send a surge of power if the receiver is bad then nothing is there a way i could test my transmitter to make sure or no lol thanks alot

 

[slowngreen]

No throttle in the channel one though either right?

 

[sata1991]

throttle in channel 2 works good trigger works awsome but channel 1 with the steering it wont move if i swap i can use the trigger to steer in channel 2. lol but still no channel one tho

 

[slowngreen]

Hmmm, not sure what to tell ya man. I'm guessing you might be right, if you can't get the throttle to work either by hooking it up to your channel one then it might be something messed up with the radios steering wheel sensor or what not.

 

[sata1991]

if i reverse channel 1 the servo moves so now i am guessing the the wheel one the transmitter lol

 

[Greywolf74]

Did you check and make sure channel one is set to 100%. If its set to 0% it might be why its not working.....seems like mine came like from the factory and it threw me for a loop for a bit.