First Timmer

[DeanJ]

So The Other Night I Decided I was Goin To Tear Apart My Engine And Port It, All Went Good But Now It Will Not Run Properly, Well, If I Blip The Throttle Twice Straight After Each Other It Flames Out???:\

Any Ideas??

Thanks In Advance

Dean

 

[Scrogg]

Got pics of what you did? What engine? Did you richen the engine some? Are you sure you put it back together correctly..ie rod and piston orientation.
The thing is one cut too far or deep can lead to internal leakage, in which case you are SOL....I've done it.

 

[DeanJ]

no pics, just a little .18 vortex vx engine, it does run and rev up high but it wont stay running if i rev it to WOT then rev it again straigh away, but i think my GP is abit dull and shot anyways will get some and see how it goes
oh and "SOL"??

 

[Metalhead Matt]

poop out of luck. Did you seal the engine and start at factory settings? May be an air leak somewhere. Also check the fuel system and tank cap for leaks.