dynamite mill

[bergoff]

i'm curious if anyone has ran this mill yet? i seen it in a magazine and asked dynamite if it would work with a ths pipe and a pull start. i'm looking to replace my 2.5 and its a direct replacement so they say. thanks shaun
http://dynamiterc.com/Products/Mach2.aspx

 

[olds97_lss]

Just an FYI, this will take you to the specs:
http://dynamiterc.com/Products/Default.aspx?ProdID=DYN0700

I'm curious as well. Would be nice to know if there's a ~$100 engine out there that performs like the 3.3. Maybe not in RPM's, but the power would be nice for that kind of money.

Having an alloy carb that is less likely to bind would be nice. Maybe the crank case would be less likely to crack as well... then I wouldn't be afraid to run my jato again! It appears that there are little support struts on the mounting flanges.

 

[alien13]

I'm wondering if it would be better than the Losi 3.4. Its got the same hp in a slightly smaller displacement.

 

[bergoff]

bump to the top