Colllari problems

[avago]

Hi all,

Have just bought a collari .30 lc30-sr engine but it didn`t have instruction for engine break in or needle settings.

If any one has info on the above it would be appreciatated.

cheers.

 

[sweetdiesel]

Here are the needle settings from the werks website

Begin by gently turning the high-speed needle all the way in, back it out seven and a half 360 degree turns. Confirm the bottom end mixture is set at four and a half turns from being bottomed out.

 

[avago]

Excellent

Thanks sweetdiesel, That help alot, I`m in the breakin stage right now.

I looked all over the web for the werks website, the one I was on didn`t have those details, Do you have the right website were you got the needle info from?
Thanks in advance

Cheers

 

[sweetdiesel]

www.werksracing.com

in the middle of the page there is a banner for "30MT starting procedure"

make sure you heat up the head with a hairdryer and loosen the glow plug slightly, I snapped my pullstart cord on the first tank because the pinch was tight.