will a o.s. 11kr carb fit my 3.3 with out mods? if not is there a good bolt in carb that will fit?
-
Welcome to RCTalk! 🚀
Join the #1 RC community where hobbyists connect, share, and get expert advice on RC cars, trucks, boats, drones, and more!
- ✓ Friendly & passionate RC enthusiasts
- ✓ RC tips & troubleshooting
- ✓ Buy, sell & trade RC gear
- ✓ Share builds & upgrades
carb fit
- Thread starter moe7404
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
links, including eBay, Amazon, and others.
MiguelRomero
RCTalk Rookie
- Messages
- 17
- Reaction score
- 0
- Points
- 0
- RC Driving Style
- Bashing
- Racing
11k should fit with no modifications. The RB 523 carb should fit too. Both are pretty expensive
I use an Ofna Force .26 carb. It's cheaper than the 11K and the RB 523, but harder to come by. Took me like 3 weeks to find this one on eBay.
I use an Ofna Force .26 carb. It's cheaper than the 11K and the RB 523, but harder to come by. Took me like 3 weeks to find this one on eBay.
I know this one will fit, it fits in my 2.5R and that uses the same carb as the 3.3:
http://www3.towerhobbies.com/cgi-bin/wti0001p?&I=LXHKW5&P=V
I tried it just to see if it would fit from my 18TM, but didn't run it.
For $90 though... pretty steep upgrade for a $150 engine.
http://www3.towerhobbies.com/cgi-bin/wti0001p?&I=LXHKW5&P=V
I tried it just to see if it would fit from my 18TM, but didn't run it.
For $90 though... pretty steep upgrade for a $150 engine.
- Thread starter
- #4
a BIG thank you to MiguelRomero and olds for good info. i just got my spool, getting ready to put it in. i think i might wait to get diff carb. thanks again.