Brushless motor black plate loose plus shaft is...

[sparkz220]

plus the shaft is pushing out forward but i took a hammer and gently knocked it back in place where it is supposed to be. I am not sure if that will work.

Also i had this motor for about 3 weeks and have been keeping an eye on temps.

The motor and esc is this http://www.nitrorcx.com/26p-blcombo-60a-12r-3300kv.html

Set up
red cat volcano epx truck 1/10 2s lipo 45c burst 21t pinion steel/ 64t spur steel
stock servo and radio 3300kv motor

update
The motor shaft is still loose after trying to fix it.

 

[Non Crimen]

Se if they sell rotor rebuild kits. Probably melted the glue for the magnets due to overheating


Sent from my *PiMP Boy-3000*

---------- Post added at 3:35 PM ---------- Previous post was at 3:34 PM ----------

Honestly I would look for something a little higher quality


Sent from my *PiMP Boy-3000*

 

[sparkz220]

Would a ez run motor by hobby wing be better?