• Welcome to RCTalk! 🚀

    Join the #1 RC community where hobbyists connect, share, and get expert advice on RC cars, trucks, boats, drones, and more!

    • Friendly & passionate RC enthusiasts
    • RC tips & troubleshooting
    • Buy, sell & trade RC gear
    • Share builds & upgrades

Broke Rx antenna wire

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.

GruberRacing97

RCTalk Champion
Messages
211
Reaction score
0
Points
0
Location
fredericksburg
RC Driving Style
I crash mr car hard enough that I tore the wire completly out of the Rx. Can I replace it myself or should I send it back?

P.S. Its a DSM system


Thanks
Stan
 
Send it back....I here horizon hobby have good costumer service...

GruberRacing97 said:
I crash mr car hard enough that I tore the wire completly out of the Rx. Can I replace it myself or should I send it back?

P.S. Its a DSM system


Thanks
Stan


Why was it sticking out of the body that far???
 
ZANDOR said:
Send it back....I here horizon hobby have good costumer service...




Why was it sticking out of the body that far???


Thanks Zandor!

I have the wire though the tube, and the tube rested on top of the Rx with no support, then layed in side my chassis with no support either. A very stupid move on my part.
 
On a standard RX I would say you could just get a replacement RX wire from your LHS or someplace like Towerhobies.com and solder it on yourself but I dont know about the DSM system. If it uses the same type of wire just make sure to cut it to the correct length and solder a new one on if your very good a soldering and dont fry your circuit board.
 
Back
Top