Brake ???

[FastEddy]

I haven’t found the need to do it. Just need to grind enough from the front part of the chassis to get the pad in. It was a mod for a .21.

I did see a pic somewhere but can't locate it.
You should be able to do front flips with it..

 

[Easy-MAXX]

you would need a light finger on the brake,or A.B.S

 

[NCNitro]

FastEddy I think I am just gonna set mine up with a stock new disc but file the angled slits in it like you explained and do the bic pen mod too, thanks for the info guys.

 

[NCNitro]

Its got to be the cheapest mod you can do to a T

 

[Divine]

I am going to try that mod in the morning I will post the results

 

[NCNitro]

I am going to the lhs moday to get a new disc so I will do mine next week.

 

[Çh®i§tiªñ]

Check out the Carbon disc by Traxxas. You might like it.

 

[NCNitro]

Christian, someone mentioned if it gets wet it dont stop at all. What is the stock disc made of?

 

[NCNitro]

I'm just gonna have to buy one of each when I go the the hs and try em both out.

 

[NCNitro]

both of em should only be around $10 so I will try both and then let you guys know.

 

[NCNitro]

Just pre order the Savage and be done with it.

 

[Çh®i§tiªñ]

Before I put on any brake disc I always lightly sand to rough it up a little.

I have run mine in the rain and had no problem braking. But I also run mine with a slight hair of drag.

 

[Çh®i§tiªñ]

To be honest - I dont know if it does or not. I just dont like the glossy look on a brake so I rough it up. I think the gloss = slip.