Brake ???

Welcome to RCTalk

Come join other RC enthusiasts! You'll be able to discuss, share and private message with other members of our community.

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
I haven’t found the need to do it. Just need to grind enough from the front part of the chassis to get the pad in. It was a mod for a .21.

I did see a pic somewhere but can't locate it.
You should be able to do front flips with it..
 
you would need a light finger on the brake,or A.B.S ;)
 
FastEddy I think I am just gonna set mine up with a stock new disc but file the angled slits in it like you explained and do the bic pen mod too, thanks for the info guys.
 
I am going to try that mod in the morning I will post the results
 
Check out the Carbon disc by Traxxas. You might like it.
 
Before I put on any brake disc I always lightly sand to rough it up a little.

I have run mine in the rain and had no problem braking. But I also run mine with a slight hair of drag.
 
To be honest - I dont know if it does or not. I just dont like the glossy look on a brake so I rough it up. I think the gloss = slip.
 
Back
Top