Childresshunt
RCTalk Addict
anyone no the size of the allen bolt that fastens a pull start or rota start to a bavkplate
-
Welcome to RCTalk! 🚀
Join the #1 RC community where hobbyists connect, share, and get expert advice on RC cars, trucks, boats, drones, and more!
- ✓ Friendly & passionate RC enthusiasts
- ✓ RC tips & troubleshooting
- ✓ Buy, sell & trade RC gear
- ✓ Share builds & upgrades
bolt size
- Thread starter Childresshunt
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
links, including eBay, Amazon, and others.
Snook Man
Hardcore RCTalk User
What engine? Some use 3mm others use 2.5mm.
Childresshunt
RCTalk Addict
- Thread starter
- #3
k 5.9 but I'm wanting to just have some on hand so I think ill just get both whats the length
Snook Man
Hardcore RCTalk User
Exploded view of the 5.9 with pull start uses these.
http://www.ebay.com/itm/HPI-94154-Flat-Head-Screw-K5-9-K4-6-Engine-/330878852092
http://www.ebay.com/itm/HPI-94154-Flat-Head-Screw-K5-9-K4-6-Engine-/330878852092
Childresshunt
RCTalk Addict
- Thread starter
- #5
thanks snook ill have to get me some along with a new backplate I woild just junk the motor bc its a 5.9 and not much good is said about to but the sleeve still has the pinch of a new motor
harbor freight has a 4" digital caliper. but check that it works before you take it home.
