AX10 torque twist

[Metalhead Matt]

My buddy has an original ax10. We're not into crawling and want to make a general basher out of it. What do we have to do to stop it from twisting so bad? Figure it's something to do with the 3 link. Figured I'd get some info while I'm waiting to get my hands on it. Thanks as always.

 

[hamz9561]

A triangulated 4-link should keep it from twisting so badly. There are quite a few aftermarket set ups available.

Sent from my SPH-D710 using Tapatalk

 

[HPI-Killer]

I Adjusted my rear shocks alittle bit tighter until I upgraded to 4link.

 

[abadk9420]

A www.eastendmachining.com double reverse triangulation skid and flipping motor and trans °180 along with the 4-link will get rid of almost all of it for you.

Sent from my Samsung Admire

 

[Metalhead Matt]

Thank ya's.