electricblue
RC Newbie
- Messages
- 4
- Reaction score
- 0
- Points
- 1
I changed my rear pinion gear to metal now the motor mount won't go all the way back. I tried several times... Any Ideas where I'm screwing up?
-
Welcome to RCTalk! 🚀
Join the #1 RC community where hobbyists connect, share, and get expert advice on RC cars, trucks, boats, drones, and more!
- ✓ Friendly & passionate RC enthusiasts
- ✓ RC tips & troubleshooting
- ✓ Buy, sell & trade RC gear
- ✓ Share builds & upgrades
Arrma Granite motor mount to pinion gear too tight
- Thread starter electricblue
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
links, including eBay, Amazon, and others.
- Messages
- 12,573
- Reaction score
- 29,511
- Points
- 1,933
- Location
- Jurassic Park
- RC Driving Style
- Bashing
- Crawling
- Scale Builder
What tooth was it at and what tooth is it now?
Is the motor screws preventing the motor from moving?
Is the motor screws preventing the motor from moving?
electricblue
RC Newbie
- Messages
- 4
- Reaction score
- 0
- Points
- 1
- Thread starter
- #3
I replaced it with stock gears 37/13 Hot Racing . Motor spins fine by itself. It's just when I slide it on the pinion it dosen't want to go all the way back. I don't get it..
I'm gonna pull the motor mount off and see if it's bent.....
I'm gonna pull the motor mount off and see if it's bent.....
Last edited:
