• Welcome to RCTalk! 🚀

    Join the #1 RC community where hobbyists connect, share, and get expert advice on RC cars, trucks, boats, drones, and more!

    • ✓ Friendly & passionate RC enthusiasts
    • ✓ RC tips & troubleshooting
    • ✓ Buy, sell & trade RC gear
    • ✓ Share builds & upgrades

Anyone know where to get special length drive shafts?

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
D

David Gray

RCTalk Member
Messages
25
Reaction score
0
Points
0
RC Driving Style
  1. Bashing
  2. Racing
My T-maxx seems to have everything on it no longer available and no brand names on anything but the engine. :angry: My rear center shaft is a dog bone and it measures 110mm from center of pin to the center of the other pin. Apparently this is longer than normal. Does anyone know where to get drive shafts. Mip is of no help so I hope to find the dog bone again, maybe even two of them. I am going to install UE diffs if I can get this drive shaft issue figured out. Please help... As allways thanks for any help.
 
X2 . Rcalloys all the way . I had Bill make me some center shafts for my Cyber-maxx . Cost 40 bucks for the pair and they are beef cake !
 
May have to scrap T-maxx over unavailable Driveshaft- Please Help

I have this T-maxx custom with apparently a longer chassis than normal. My rear driveshaft is dogbone on both ends and measures 110mm center to center of the drive pins. Rc alloys no longer does drivelines as of 2-01-10 and I can't seem to figure out where to get another. Does anyone know what else might work? If I don't find another I will have to go with my LST2 and dump this thing, it has been nothing but hard to find parts for. Please help so I can keep it going for my son. My LST2 is out a ways from being done and he has had to wait already for a major clutch issue we just went thru and oh ya after that a wheel bearing broke causing damage to the knuckle and now this. As allways thank you for the help.
 
Rc Alloys no longer does driveshafts as of 2-01-10

Lessen said:
www.rcalloys.com
Click to expand...

Thanks for the lead but apparently they don't do driveshafts anymore. Do you have another idea? Is there another truck that takes a similar driveshaft length? I could use one with dog bone on one side and cv on the other. MIP was of no help to me. Thanks again
 
chop and braze. make sleeve that press fits the shaft, then braze through holes in the sleeve
 

RC Builds

Back
Top