Anyone know of an imperial clutch nut for SG crank?

[SamJG04]

Hi all, new engine is here.

Got the trackstar SEG-H-28 off of hobbyking (what could go wrong) and not having great lunch with it so far, in that no form of engine mounts fit and the crank is wierd.

I tried the standard 6mm clutch nut but this thread is 1/4 inch (6.3mm) so naturally doesn't fit. Cannot find an imperial one for an SG crank at all, only ones for a standard crank.

Does anyone have any links to where I can find one or am I in trouble here?

Thanks

 

[monstertruckier15]

Must be a 1/4-28 thread.

 

[SamJG04]

Yeah that's right

 

[monstertruckier15]

1set Clutch Bell 14T Gear Flywheel Cone & Engine Nut for 1/8 RC Model Nitro Car | eBay
I see you can get the separate $5-10. check you kit instructions.

 

[SamJG04]

Cheers! Not the same link but I found one made by HPI (86086) so will post it here:
https://wheelspinmodels.co.uk/i/1024/

 

[SamJG04]

Update: This doesn't fit either! Its like 0.2in which makes absolutely no sense. Still looking for another.

Is anyone able to tell me what size nut the HPI trophy 3.5 takes with the stock engine?
Thanks

 

[SamJG04]

Sorry my mistake this DOES fit - Its just extremely tight and looks like it doesn't
Apologies for the confusion