I can take the electronics and engine out of it, but I didn't want to bother if there wasn't any interest.
I bashed it a bit last summer, but for the places I drive, it doesn't work well. The place it did the best was just dirt, but it grew over with weeds, big weeds that can stop a 14lb truck dead from WOT.
Spare Parts:
17mm hubs w/17mm stock rims/tires with plenty of tread
front/rear arms
hinge pins
hinge pin holders (couple sets)
two speed mechanism
two speed gears (new set and used set in good condition)
two speed clutch bell (possibly bearings as well)
Front skid/bumper
Large fuel tank
Front/rear diff/diff case/output diff cups
Full set of cvd's/dog bones (front/rear/center)
MGT stock body
Stock rear chassis braces
Steering rack bearings
Installed:
Center diff w/ 50K OFNA
14mm hubs
125cc fuel tank (might be a 150)
Homemade rear chassis braces
MGT stock body
1200Mah receiver pack
Front skid/bumper on the rear as well.
I don't recall what clutch bell I have on it, it's OFNA, I just don't remember the tooth count. I have the stock 3 shoe flywheel and savage teflon shoes.
It has an axial 28 on it, but used engines don't add much value regardless who the seller is. Besides, they can be bought for $99. I'm intending on keeping the engine and possibly shoehorning it into my revo.
I can include 645MG servo's for more $, but it really should have something stronger for steering. I'm looking to get $150 shipped without servo's.
I'll take it apart and post pics of it as a roller if there is any interest. Here are photo's of how it sits currently:
Here's a pic of what it looked like when I bought it, it has the larger fuel tank:
I bashed it a bit last summer, but for the places I drive, it doesn't work well. The place it did the best was just dirt, but it grew over with weeds, big weeds that can stop a 14lb truck dead from WOT.
Spare Parts:
17mm hubs w/17mm stock rims/tires with plenty of tread
front/rear arms
hinge pins
hinge pin holders (couple sets)
two speed mechanism
two speed gears (new set and used set in good condition)
two speed clutch bell (possibly bearings as well)
Front skid/bumper
Large fuel tank
Front/rear diff/diff case/output diff cups
Full set of cvd's/dog bones (front/rear/center)
MGT stock body
Stock rear chassis braces
Steering rack bearings
Installed:
Center diff w/ 50K OFNA
14mm hubs
125cc fuel tank (might be a 150)
Homemade rear chassis braces
MGT stock body
1200Mah receiver pack
Front skid/bumper on the rear as well.
I don't recall what clutch bell I have on it, it's OFNA, I just don't remember the tooth count. I have the stock 3 shoe flywheel and savage teflon shoes.
It has an axial 28 on it, but used engines don't add much value regardless who the seller is. Besides, they can be bought for $99. I'm intending on keeping the engine and possibly shoehorning it into my revo.
I can include 645MG servo's for more $, but it really should have something stronger for steering. I'm looking to get $150 shipped without servo's.
I'll take it apart and post pics of it as a roller if there is any interest. Here are photo's of how it sits currently:
Here's a pic of what it looked like when I bought it, it has the larger fuel tank:
Last edited:
